TPMS Reset-Ford Crown Victoria 2007-2011 Tire Pressure Sensor

Ford Crown Victoria 2007-2011 Tire Pressure Monitoring System TPMS Reset

Easy to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Ford Crown Victoria for the year 2007 and 2011.

A TPMS Tool, or another properly formatted TPMS scan tool, is required to perform this procedure.

Relearn Procedure for Models WITH STANDARD IGNITION

1. Inflate all tires to pressure listed on vehicle placard.

2. Leave the driver’s door open during the relearn procedure.

3. Turn ignition to OFF position and press and release brake pedal.

4. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position.

5. Press and release brake pedal.

6. Turn ignition to OFF position.

7. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position.

8. Horn will sound once, and the TPMS telltale will blink once, indicating train mode is initiated. If equipped with a message center, it will display TRAIN LF TIRE.

9. Starting with the LF tire, use your TPMS Tool to scan each sensor in the following order: LF, RF, RR, LR (and full size spare if equipped). The horn will sound once each sensor has been recognized.

10. After training LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, then the training procedure must be repeated.

11. Turn ignition to the OFF position.

Relearn Procedure for Models WITH PUSH-BUTTON IGNITION

NOTE: some models require the ignition button to be pressed twice, without pressing the brake, to enter the RUN mode (Ignition ON/Engine OFF). If this is the case, then modify steps 4 and 6 as noted.

1. Inflate all tires to pressure listed on vehicle placard.

2. Leave the driver’s door open during the relearn procedure.

3. With the vehicle OFF, press and release the brake pedal.

4. Press the IGNITION BUTTON 5 times (NOTE: 8 times if 2x-to-RUN).

5. Press and release the brake pedal.

6. Press the IGNITION BUTTON 6 times (NOTE: 9 times if 2x-to-RUN). Horn will sound once, and the TPMS telltale will blink once, indicating train mode is initiated. If equipped with a message center, it will display TRAIN LF TIRE.

7. Starting with the LF tire, use your TPMS Tool to scan each sensor in the following order: LF, RF, RR, LR (and full size spare if equipped). The horn will sound once after each sensor has been recognized.

8. After training LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, then the training procedure must be repeated.

9. Press the IGNITION BUTTON 1 time to turn the vehicle OFF.

About Ford Crown Victoria

The Ford Crown Victoria (“Crown Vic”) is a full-size sedan that was marketed and manufactured by Ford. The successor to the Ford LTD Crown Victoria, two generations of the model line were produced from the 1992 to 2012 model years. The Ford counterpart of the Mercury Grand Marquis, the Crown Victoria was the largest sedan marketed by Ford in North America, slotted above the Ford Taurus. The Crown Victoria Police Interceptor (1992–2011) was marketed specifically for law-enforcement use; a long-wheelbase Crown Victoria sedan (2002–2011) was marketed primarily for taxi cab fleets. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *