TPMS Reset: Dodge Caliber 2007-2012 Tire Pressure Sensor
Dodge Caliber 2007-2012 Tire Pressure Monitoring System TPMS Reset
Simple to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Dodge Caliber for the year 2007, 2010, 2011 and 2012.
Sensor Relearn Procedure without a Scan Tool:
1. Inflate all tires to pressure listed on the placard.
2. Turn the ignition to the ON position with the engine OFF (not the ACC position), and roll the driver’s side window down.
3. Let the vehicle sit, for 20 minutes, with the ignition ON. Turn the climate controls/NAV system OFF to limit battery drain.
4. During the 20 minutes, scan each sensor.
5. Drive the vehicle above 15 MPH for at least 20 minutes. All sensor IDs will be memorized automatically.
Sensor Relearn Procedure with a Scan Tool (If Available):
1. Inflate all tires to pressure listed on the placard.
2. Select OBD II (PERFORM RELEARN on the ELITE Tool) from your Tool’s menu.
3. Starting with the LF tire, use your Tool to scan each sensor in the following order: LF, RF, RR and LR (and the full size spare if equipped).
4. After all sensor IDs have been read, turn the ignition to the ON position with the engine OFF (not the ACC position).
5. Connect the OBD II Connector to the Tool then to the vehicle’s OBD II port. Make sure your connection is secure and the green light is on.
6. Select UPLOAD CAR IDS, from the Tool’s menu, and upload the sensor IDs.
7. When RELEARN COMPLETE / IDs UPLOADED TO CAR is displayed, the IDs have been successfully uploaded.
8. With the ignition still in the ON position, re-scan each sensor.
9. Drive the vehicle above 15 MPH, for at least 20 minutes, and monitor the low tire pressure monitor to ensue it does not blink.
About Dodge Caliber
The Dodge Caliber is a front-engine, front-wheel drive five-door compact hatchback manufactured and marketed by Chrysler’s Dodge division from model years 2007 to 2012, replacing the Dodge Neon and Chrysler PT Cruiser.
Following the Caliber concept which debuted at the 2005 Geneva Motor Show, the pre-production version debuted at the 2006 North American International Auto Show, with market launch in March 2006.
The Caliber was manufactured at the Belvidere Assembly (Illinois) plant, and across its six-year model run, just over 400,000 were produced. (Source Wiki)
