counter create hit

TPMS Reset: Dodge Stratus 2007 Tire Pressure Sensor

0
TPMS Reset-Dodge Stratus 2007 Tire Pressure Sensor

Dodge Stratus 2007 Tire Pressure Monitoring System TPMS Reset

Simple to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Dodge Stratus for the year 2007.

Sensor Relearn Procedure without a Scan Tool:

1. Inflate all tires to pressure listed on the placard.

2. Turn the ignition to the ON position with the engine OFF (not the ACC position), and roll the driver’s side window down.

3. Let the vehicle sit, for 20 minutes, with the ignition ON. Turn the climate controls/NAV system OFF to limit battery drain.

4. During the 20 minutes, scan each sensor.

5. Drive the vehicle above 15 MPH for at least 20 minutes. All sensor IDs will be memorized automatically.

Sensor Relearn Procedure with a Scan Tool (If Available):

1. Inflate all tires to pressure listed on the placard.

2. Select OBD II (PERFORM RELEARN on the ELITE Tool) from your Tool’s menu.

3. Starting with the LF tire, use your Tool to scan each sensor in the following order: LF, RF, RR and LR (and the full size spare if equipped).

4. After all sensor IDs have been read, turn the ignition to the ON position with the engine OFF (not the ACC position).

5. Connect the OBD II Connector to the Tool then to the vehicle’s OBD II port. Make sure your connection is secure and the green light is on.

6. Select UPLOAD CAR IDS, from the Tool’s menu, and upload the sensor IDs.

7. When RELEARN COMPLETE / IDs UPLOADED TO CAR is displayed, the IDs have been successfully uploaded.

8. With the ignition still in the ON position, re-scan each sensor.

9. Drive the vehicle above 15 MPH, for at least 20 minutes, and monitor the low tire pressure monitor to ensue it does not blink.

About Dodge Stratus

The Dodge Stratus is a mid-size car that was introduced by Dodge in February 1995 and was based on the 4-door sedan Chrysler JA platform. The Stratus, Plymouth Breeze, and Chrysler Cirrus were all on Car and Driver magazine’s Ten Best list for 1996 and 1997. It received critical acclaim at launch, but ratings fell over time. An updated version of the Stratus was introduced for 2001, with the Cirrus being renamed as the Chrysler Sebring, and a coupé model was also added to the range. However, production ended in early 2006 at the Sterling Heights Assembly Plant, which had built 1,308,123 Stratus and Sebrings since 2000. The Dodge Avenger replaced the Stratus nameplate in early 2007 for the 2008 model year.

After the discontinuation of the Stratus sedan in 2006, the assembly line and tooling were sold to the Russian concern, GAZ, which manufactured 9,000 examples of a very slightly modified Stratus from 2008 through 2010 called the Volga Siber. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *

error: Content is protected !!