KeyFob RKE Programming Procedure: Toyota Highlander 2004-2010

KeyFob RKE Programming Procedure-Toyota Highlander 2004-2010

Toyota Highlander 2004-2010 KeyFob Remote Keyless Entry Programming Procedure

 

 

How to Program Toyota Highlander KeyFob Remote Keyless Entry for the year 2004 and 2010.

 

 

Programming Procedure

  1. First, close all doors
  2. Insert master Toyota key in and out of ignition cylinder 4 times. On the 5th time leave the master key in the ignition cylinder
  3. Open and close driver’s side door 6 times
  4. Remove master key from ignition cylinder.
  5. Verify that security light on the information display is solid, indicating that the car successfully entered programming mode
  6. Insert new chip key
  7. Watch security light blinking for about 60 seconds
  8. When security light goes out, your new key is successfully programmed
  9. Remove new key from the ignition cylinder
  10. And finally, verify that your new key is able to deactivate anti-theft system: security indicator light on the information display should disappear when inserting properly programmed key into ignition cylinder
  11. If it didn’t work, repeat the same steps from the beginning

 

 

About Toyota Highlander

In 2010, for the 2011 model year, Toyota made some changes to the Highlander and Highlander Hybrid. While the general design remains similar to the 2010 model, the Highlander’s front end has been significantly revised, now featuring new headlights, a new black with chrome accent rocker panel, and new front grille.

The non-hybrid engines for 2011 remain the same, although now the 2.7-liter four-cylinder engine may be had on the SE trim level, previously only available on the base model. More standard features are now equipped on all trim levels, with the base model receiving front and rear air conditioning, power locks/windows, cruise control, and a multi-function keyless entry control. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *