KeyFob RKE Programming Procedure: Mitsubishi Galant Wagon 1997-2003

Mitsubishi Galant Wagon 1997-2003 KeyFob Remote Keyless Entry Programming Procedure

 

 

How to Program Mitsubishi Galant Wagon KeyFob Remote Keyless Entry for the year 1997 and 2003

Key Fob Programming Procedure (Remote)

 

Programming Procedure

Note. If the central locking / alarm system is malfunctioning or a replacement key fob is obtained. The following programming procedure is required to be carried out before the key fob will operate correctly. Maximum of 2 Remotes can be programmed

 

  • Connect a link wire between Pin 4 and Pin 1 on the J1962 Connector
  • Close all Doors
  • Turn Ignition to ACC position and the back to Off 3 Times with in 10 Seconds
  • Doors Should lock then unlock
  • Press remote control lock or Unlock button once
  • Press remote control lock or Unlock button twice within 10 Seconds
  • Doors Should lock then unlock
  • Repeat for Second Remote

 

KeyFob RKE Programming Procedure: Mitsubishi Galant Wagon 1997-2003

 

 

 

About Mitsubishi Galant Wagon

The third generation of the car was introduced in 1976, and was known as Galant Σ (Sigma). In many export markets the car was simply known as the Galant. At that time, the Dodge Colt in America was actually a Mitsubishi Lancer, not the Galant anymore, but nonetheless the Galant Wagon variant was sold with the Dodge Colt label in the US and Canada. In Australia, where the car was made locally at Chrysler’s Clovelly Park plant, it was marketed as the Chrysler Sigma and, after the 1980 buyout of Chrysler Australia by Mitsubishi, as the Mitsubishi Sigma. Australian content was quite high and included a locally-made 2.6-litre ‘Astron’ four (introduced 1980) which, in December 1985, replaced the 1.6, 1.85 and two-litre engines used in other export markets. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *