KeyFob RKE Programming Procedure: Toyota Corolla
Toyota Corolla KeyFob Remote Keyless Entry Programming Procedure
How to Program Toyota Corolla KeyFob Remote Keyless Entry
Key Fob Programming Procedure (Remote)
Remote programming is a manual process for all vehicles supported.
Please follow the procedures set out below to ensure accurate programming of the remotes.
Please ensure the following has been carried out before starting:
All Doors are closed
Start the vehicle and then stop the vehicle.
Remove key from the ignition switch.
Open the Drivers door and ensure it is unlocked.
- Insert key in the ignition for 2 seconds and then remove.
- Within 40 seconds: Close the driver’s door for 2 seconds and then open.
- Wait 2 seconds: Close the driver’s door for 2 seconds and then open
- Insert key in the ignition for 2 seconds and then remove.
- Within 40 seconds: Close the driver’s door for 2 seconds and then open
- Wait 2 seconds: Close the driver’s door for 2 seconds and then open
- Close Drivers Door.
To Program an additional remote whilst retaining all other remotes programmed.
- Insert Key in the ignition switch and wait 2 seconds
- Switch ignition on for 2 seconds and then turn off.
- Remove key
- System should lock and unlock once.
Note: Please start the following procedure within the next 20 seconds.
For Vehicle manufactured in Japan: Simultaneously hold the LOCK and UNLOCK buttons on the remote for 1-1.5 seconds and then release.
For Vehicles not manufactured Japan: Press the LOCK button on the remote for a minimum of 1 second and then release.
- Within 3 seconds press the lock button for 1 second and then release.
- System should lock and unlock once.
To Program an additional remote and remove all other remotes programmed.
- Insert Key in the ignition switch and wait 2 seconds
- Switch ignition on for 2 seconds and then turn off.
- Switch ignition on for 2 seconds and then turn off.
- Remove key
- System should lock and unlock twice.
Note: Please start the following procedure within the next 20 seconds.
For Vehicles manufactured in Japan: Simultaneously hold the LOCK and UNLOCK buttons on the remote for 1-1.5 seconds and then release.
For Vehicles not manufactured in Japan: Press the LOCK button on the remote for a minimum of 1 second and then release.
- Within 3 seconds press the lock button for 1 second and then release.
- System should lock and unlock once.
- If system locks and unlocks twice then the procedure has not been completed.
- To Exit Programming mode open driver’s door
About Toyota Corolla
Early models were mostly rear-wheel drive, while later models have been front-wheel drive. Four-wheel drive versions have also been produced. The Corolla’s traditional competitors have been the Nissan Sunny, introduced the same year as the Corolla in Japan and the later Honda Civic and Mitsubishi Lancer. The Corolla’s chassis designation code is “E”, as described in Toyota’s chassis and engine codes. (Source Wiki)
