counter create hit

TPMS Reset: Mercury Sable 2008-2009 Tire Pressure Sensor

0
TPMS Reset-Mercury Sable 2008-2009 Tire Pressure Sensor

Mercury Sable 2008-2009 Tire Pressure Monitoring System TPMS Reset

Quick to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Mercury Sable for the year 2008 and 2009.

A TPMS Tool, or another properly formatted TPMS scan tool, is required to perform this procedure.

 

Relearn Procedure for Models WITH STANDARD IGNITION

1. Inflate all tires to pressure listed on vehicle placard.

2. Leave the driver’s door open during the relearn procedure.

3. Turn ignition to OFF position and press and release brake pedal.

4. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position.

5. Press and release brake pedal.

6. Turn ignition to OFF position.

7. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position.

8. Horn will sound once, and the TPMS telltale will blink once, indicating train mode is initiated. If equipped with a message center, it will display TRAIN LF TIRE.

9. Starting with the LF tire, use your TPMS Tool to scan each sensor in the following order: LF, RF, RR, LR (and full size spare if equipped). The horn will sound once each sensor has been recognized.

10. After training LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, then the training procedure must be repeated.

11. Turn ignition to the OFF position.

 

Relearn Procedure for Models WITH PUSH-BUTTON IGNITION

NOTE: Some models require the ignition button to be pressed twice, without pressing the brake, to enter the RUN mode (Ignition ON/Engine OFF). If this is the case, then modify steps 4 and 6 as noted.

1. Inflate all tires to pressure listed on vehicle placard.

2. Leave the driver’s door open during the relearn procedure.

3. With the vehicle OFF, press and release the brake pedal.

4. Press the IGNITION BUTTON 5 times (NOTE: 8 times if 2x-to-RUN).

5. Press and release the brake pedal.

6. Press the IGNITION BUTTON 6 times (NOTE: 9 times if 2x-to-RUN). Horn will sound once, and the TPMS telltale will blink once, indicating train mode is initiated. If equipped with a message center, it will display TRAIN LF TIRE.

7. Starting with the LF tire, use your TPMS Tool to scan each sensor in the following order: LF, RF, RR, LR (and full size spare if equipped). The horn will sound once after each sensor has been recognized.

8. After training LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, then the training procedure must be repeated.

9. Press the IGNITION BUTTON 1 time to turn the vehicle OFF

 

About Mercury Sable

The fifth-generation Mercury Sable was launched for the 2008 model year. Developed as a mid-cycle update of the Mercury Montego, the production vehicle revived the more widely-recognized Sable nameplate at the 2007 Chicago Auto Show. While the 2008 revival of the Ford Taurus (renaming the Five Hundred) largely ended retail sale of the Crown Victoria, the Sable remained slotted below the Grand Marquis in the Mercury model line. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *

error: Content is protected !!