TPMS Reset: Mercedes-Benz G Class 2007-2019 Tire Pressure Sensor

Mercedes-Benz G Class 2007-2019 Tire Pressure Monitoring System TPMS Reset
Easy to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Mercedes-Benz G Class for the year 2007, 2013, 2014 and 2019.
No special tools are required to perform this relearn procedure.
Relearn Procedure when Resetting Air Pressure:
1. Inflate all tires to pressure listed on tire placard.
2. Turn the ignition to the ON position with the engine OFF.
3. Press forward/back button on the steering wheel until trip and odometer are displayed.
4. Press UP/DOWN button until tire pressure monitor is displayed.
5. Hold down reset button (located on the instrument cluster) until MONITOR CURRRENT TIRE PRESURE is displayed.
6. Press + button. TIRE RESS. MONITOR‐ACTIVATED‐PRESS. DISPLAY AFTER DRIVING A FEW MINS. Is displayed.
7. If REACTIVATE‐TIRE PRESS. MONITOR! Appears, repeat relearn procedure.
8. If TIRE PRESSURE‐CHECK TIRES! appears, the tire pressure is too low. Adjust pressure(s) accordingly.
Relearn Procedure when Replacing Sensors:
1. Inflate all tires to pressure listed on tire placard.
2. Drive the vehicle for at least 10 minutes at a speed of 15 MPH, or more. All sensor IDs will be memorized automatically.
NOTES: If the vehicle does not relearn the new sensor IDs, verify that the spare wheel was not introduced onto the vehicle. If the sensors that was originally assigned to the spare position is replaced, then the new spare sensor ID has to be register through the OBDII via a properly formatted scan tool.
If the spare tire sensor ID is being programmed, a properly formatted scan tool is necessary.
About Mercedes-Benz G Class
The second generation G-Class (W463) was launched on 14 January 2018 at the North American International Auto Show in Detroit.
In contrast to its predecessor, the new G-Class has grown 121 millimetres in width and 53 millimetres in length. The ground clearance has increased by 6 millimetres.The increase in width is for more driving stability, sturdier side impact protection, and more seating comfort. The increased length, especially in the front end, is due to the new 2019 EU pedestrian impact safety regulations: the previous generation did not have enough open space between the car’s front end and the rigid components beneath for the crumple zone as to mitigate the injury to a pedestrian’s body. (Source Wiki)