KeyFob RKE Programming Procedure: Seat Cordoba 1993-1999
Seat Cordoba 1993-1999 KeyFob Remote Keyless Entry Programming Procedure
Re-initializing Procedure – Infrared Key fobs
Note. If battery is replaced inside key fob or if key fob buttons are operated repeatedly whilst vehicle is out of range and central locking / alarm system becomes inoperative, carry out the following reinitializing procedure.
- Point key fob at infrared receiver located in rear view mirror.
- Press both the “Lock” and “Unlock” buttons together on the key fob twice.
- Repeat above procedure to re-initialize any remaining key fobs.
- Confirm operation of key fob by locking and unlocking vehicle using key fob buttons.
Re-initializing Procedure – Radio frequency Key fobs
Note. If battery is replaced inside key fob or if key fob buttons are operated repeatedly whilst vehicle is out of range and central locking / alarm system becomes inoperative, carry out the following reinitializing procedure.
- Press both the “Lock” and “Unlock” buttons together on the key fob twice.
- Repeat above procedure to re-initialize any remaining key fobs.
- Confirm operation of key fob by locking and unlocking vehicle using key fob buttons.
About Seat Cordoba
The first generation Córdoba was presented at the 1993 Frankfurt Motor Show, and launched in the summer of the same year, penned by Italian designer Giorgetto Giugiaro and based on the chassis of the SEAT Ibiza Mk2.
The first generation was officially unveiled in February 1993. Its 1.4, 1.6, 1.8 and 2.0 litre petrol engines were also found in the Volkswagen Polo and Ibiza, as was the 1.9 TDI.
Though based on the Ibiza, its extended rear overhang meant its length was close to a Golf, but still smaller than the Jetta. It featured a boot space of 455 litres (16.1 cu ft) which could be extended up to 762 litres (26.9 cu ft) by folding rear seats. (Source Wiki)
