KeyFob RKE Programming Procedure: Peugeot 206 2001

Peugeot 206 2001 (Peugeot 3) KeyFob Remote Keyless Entry Programming Procedure

How to Program Peugeot 206 KeyFob Remote Keyless Entry for the year 2001

Re-initializing Procedure

Note. If battery is replaced inside key fob or if key fob buttons are operated repeatedly whilst vehicle is out of range and central locking / alarm system becomes inoperative, carry out the following reinitializing procedure.

Unlock the Drivers door using the key
Press and hold the “Lock / Unlock” button on the key fob
The LED on the key fob should start to flash

Wait for approximately 20 seconds and then with the “Lock / Unlock” button still held, press and release the double locking button on the key fob.
The LED on the key fob will stop flashing
Release the “Lock / Unlock” button on the key fob
The LED on the key fob will remain illuminated
Press and release the “Lock / Unlock” button on the key fob
The LED on the key fob will turn “OFF”
Open the driver’s side door and sit in the driver’s seat.
Close the driver’s side door
Hold the key fob next to the ignition switch
Press and release the “Lock / Unlock” button on the key fob
Switch the ignition to the “ON” position
Wait 10 seconds
Switch the ignition to the “OFF” position
Wait 5 seconds
Key fob is re-initialized.
Confirm operation of key fob by locking and unlocking vehicle using key fob buttons.
Repeat above procedure to re-initialize any remaining key fobs.

About Peugeot 206

Iran Khodro Company (IKCO), which produces the Peugeot 206 in Iran since April 2001, has announced the production of the “207i” in hatchback version. In the initial phase, 5,000 Peugeot 207i (206+) cars would be produced by the end of the current Iranian year (March 2010), and will increase to 15,000–20,000 annually. At the end of year 2011, 207i producing in IKCO stopped temporary during relation cut between IKCO and Peugeot because of international sanctions against Iran. However, in early 2016 its production restarted in Iran. (Source Wiki)