KeyFob RKE Programming Procedure: Ford Mondeo 1996-2000

Ford Mondeo 1996-2000 KeyFob Remote Keyless Entry Programming Procedure

 

 

Programming Procedure – Infrared key fobs

Note. If the central locking / alarm system is malfunctioning, key fob batteries have been replaced or a replacement key fob is obtained. The following programming procedure is required to be carried out before the key fob will operate correctly.

 

  • Obtain all keys fitted with remote key fob for vehicle.
  • Fasten seat belts and close all doors.
  • Using any key, switch the ignition from position “I” to position “II” at least 4 times in 6
    seconds.
  • Programming mode activated for approximately 10:
    o Point the key fob at the infrared receiver (located in front door handles)
    o Press and hold either the “Lock” or “Unlock” button on the key fob

KeyFob RKE Programming Procedure: Ford Mondeo 1996-2000

 

  • An audible warning will sound to indicate successful programming
  • Within the next 10 seconds: Repeat above procedure to re-program remaining key fobs
  • To exit programming mode: Start the engine and wait 10 seconds
  • Confirm operation of key fobs by locking and unlocking vehicle using key fob buttons.

 

Note. A maximum of 4 key fobs can be programmed to the vehicle. Programming Procedure – Radio frequency key fobs

Note. If the central locking / alarm system is malfunctioning or a replacement key fob is obtained. The following programming procedure is required to be carried out before the key fob will operate correctly.

  • Obtain all keys fitted with remote key fobs
  • Switch the ignition “ON” 4 times within 3 seconds
  • Switch the ignition “OFF” and remove key from ignition switch
  • Programming mode activated for approximately 20 seconds (System alarm LED
    remains illuminated):
    o Type 1 key fob: Press and release either the “Lock” or “Unlock” button on the key fob

KeyFob RKE Programming Procedure: Ford Mondeo 1996-2000

    • Type 2 Key fob: Press and release either the “Lock” or “Unlock” button on the key fob

KeyFob RKE Programming Procedure: Ford Mondeo 1996-2000

  • The system Alarm LED will flash to indicate successful programming
  • Wait 2 seconds
  • Within 20 seconds: Repeat above procedure to re-program remaining key fobs.
  • To exit programming mode: Switch ignition “ON” and wait 20 seconds
  • Confirm operation of key fobs by locking and unlocking vehicle using key fob buttons.

Note. A maximum of 4 key fobs can be programmed to the vehicle.

 

 

About Ford Mondeo

In North America, the Mk I and Mk II Mondeo were produced and marketed as the Ford Contour and Mercury Mystique from 1995 to 2000. The 1999-2002 Mercury Cougar is a rebodied three-door hatchback variant of the Mk II, sold as the Ford Cougar in export markets.

The Mk V Ford Mondeo is the second Mondeo designed as a “world car”, as it adopts the Ford Fusion nameplate in the Americas, Middle East, and South Korea. In January 2016, Ford showcased a facelift in USA for model year 2017. As of June 2018, it was unknown whether this facelift would be brought to Europe and the Mondeo branded version. The current Mondeo is still the pre-facelift of the Ford Fusion. Ford Fusions have a conventional trunk lid, distinguished from the world market Mondeo which has a large hatchback, including the “trunk lid” and rear glass; the cars are virtually identical in side view. (Source Wiki)

Leave a Reply

Your email address will not be published. Required fields are marked *