TPMS Reset-Dodge Nitro 2007-2012 Tire Pressure Sensor

TPMS Reset: Dodge Nitro 2007-2012 Tire Pressure Sensor

Dodge Nitro 2007-2012 Tire Pressure Monitoring System TPMS Reset

Easy to follow procedure on how to reset/relearn the TPMS service maintenance indicator warning light on Dodge Nitro for the year 2007, 2009, 2010 and 2012.

Sensor Relearn Procedure without a Scan Tool:

1. Inflate all tires to pressure listed on the placard.

2. Turn the ignition to the ON position with the engine OFF (not the ACC position), and roll the driver’s side window down.

3. Let the vehicle sit, for 20 minutes, with the ignition ON. Turn the climate controls/NAV system OFF to limit battery drain.

4. During the 20 minutes, scan each sensor.

5. Drive the vehicle above 15 MPH for at least 20 minutes. All sensor IDs will be memorized automatically.

Sensor Relearn Procedure with a Scan Tool (If Available):

1. Inflate all tires to pressure listed on the placard.

2. Select OBD II (PERFORM RELEARN on the ELITE Tool) from your Tool’s menu.

3. Starting with the LF tire, use your Tool to scan each sensor in the following order: LF, RF, RR and LR (and the full size spare if equipped).

4. After all sensor IDs have been read, turn the ignition to the ON position with the engine OFF (not the ACC position).

5. Connect the OBD II Connector to the Tool then to the vehicle’s OBD II port. Make sure your connection is secure and the green light is on.

6. Select UPLOAD CAR IDS, from the Tool’s menu, and upload the sensor IDs.

7. When RELEARN COMPLETE / IDs UPLOADED TO CAR is displayed, the IDs have been successfully uploaded.

8. With the ignition still in the ON position, re-scan each sensor.

9. Drive the vehicle above 15 MPH, for at least 20 minutes, and monitor the low tire pressure monitor to ensue it does not blink.

About Dodge Nitro

The Dodge Nitro is a compact SUV that was produced by Dodge from the 2007 to the 2012 model year to compete with the likes of the Ford Escape and Hyundai Tucson. The Nitro shared its platform with the second generation Jeep Liberty. It was assembled at the Toledo North Assembly Plant in Toledo, Ohio. The Jeep facility is part of an automobile complex which includes the Toledo South Assembly Plant, home to Jeep since the 1940s. (Source Wiki)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *