KeyFob RKE Programming Procedure: Rover 100 Series 1995-1998
Rover 100 Series 1995-1998 KeyFob Remote Keyless Entry Programming Procedure
How to Program Rover 100 Series KeyFob Remote Keyless Entry for the year 1995 and 1998
KeyFob Programming Procedure (Remote)
Re-initializing Procedure
Note. If battery is replaced inside key fob or if key fob buttons are operated repeatedly whilst vehicle is out of range and central locking / alarm system becomes inoperative, carry out the following reinitializing procedure.
- Manually “Unlock” the vehicle using the key
- Ensure all of the doors, Bonnet and Boot are all closed and both front doors are unlocked.
- Hold the remote key fob close to the vehicle
- Press the “Padlock” or “Dimpled” button on the key fob button 4 times or more in quick succession, until the vehicle locks are enabled.
- Key fob is re-initialized.
- Repeat above procedure for all remaining key fobs
- Confirm operation of key fobs by locking and unlocking vehicle using key fob buttons.
About Rover 100
The Rover 90 and Rover 105 were replaced by the more powerful 100 announced on 24 October 1959. Its new but similar 2.6 litres (160 cu in) IOE straight-6 engine was a short-stroke version of the P5 3-Litre unit. The 100 could reach 100 mph (161 km/h). The interior was luxurious, with wood and leather accents on traditional English car elements like a curved “Shepherds Crook” handbrake lever. A bench front seat or individual front seats could be ordered. A heater was a standard fitting. Like the smaller 80 version, the 100 was fitted with servo-assisted Girling disc brakes at the front, keeping drum brakes at the rear. Overdrive, on top gear only, was a standard fitting.
Production ended in 1962, by which time 16,521 had been produced. (Source Wiki)
