KeyFob RKE Programming Procedure-Honda S2000 2000-2003

KeyFob RKE Programming Procedure: Honda S2000 2000-2003

Honda S2000 2000-2003 KeyFob Remote Keyless Entry Programming Procedure

 

Programming Procedure

Note. If the central locking / alarm system is malfunctioning or a replacement key fob is obtained. The following programming procedure is required to be carried out before the key fob will operate correctly. Maximum of 3 Remotes can be programmed.

  • Obtain all remote controls
  • Switch the ignition “ON”
  • Within 4 Seconds – Press the Unlock or Lock Button
  • Within 4 Seconds – Switch the Ignition “OFF”
  • Within 4 Seconds – Switch the Ignition “ON”
  • Within 4 Seconds – Press the Unlock or Lock Button
  • The system should Unlock or Lock the vehicle
  • Within 4 Seconds – Press the Unlock or Lock Button
  • Within 15 Seconds – Press the Unlock or Lock Button of each remote that is to be programmed
  • Switch the Ignition “OFF”
  • Remove the Ignition Key
  • Check the operation of each remote Fob.

 

KeyFob RKE Programming Procedure: Honda S2000 2000-2003

 

About Honda S2000

The S2000 was introduced in 1999 for the 2000 model year and was given the chassis designation of “AP1”. It features a front mid-engine, rear-wheel-drive layout with power delivered by a 1,997 cc (122 cu in) inline four-cylinder DOHC-VTEC engine. The engine (codenamed F20C) generates power outputs of 177–184 kW (241–250 PS; 237–247 hp), and 208–218 N⋅m (153–161 lbf⋅ft) of torque depending on the target market.

The engine is mated to a six-speed manual transmission and Torsen limited slip differential. The S2000 achieved what Honda claimed as the highest specific output of a normally aspirated production automobile engine in the world. The most powerful version; the JDM F20C was rated at 184 kW (250 PS; 247 hp) or 92 kW (125 PS; 123 hp) per litre as a result of a higher 11.7:1 compression ratio. (Source Wiki)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *